How to Clear Wet Leaves From a Driveway or Patio

A cleaner porch with less effort

Short answer: wet leaves need speed and an angle. Use the highest speed, a long tube held close to the ground at a shallow angle, and work in short passes from the edges toward one pile. Then bag or compost the pile.

Why wet leaves are harder

Water makes leaves heavier and glues them to concrete and pavers. A wide, slow airflow slides over them. You need the air to get under the edge of the leaf, which means speed at a low angle.

Step by step

  1. Pick the pile spot first: the lawn edge, a tarp, or the curb if your town allows it.
  2. Fit the long tube so the air hits the ground close to your feet, without bending over.
  3. Hold the tube low, almost parallel to the ground, a foot or two in front of you.
  4. Start at the far edges (along the garage, the walls, the fence) and push toward the middle.
  5. Work in short, overlapping passes. Let the first pass loosen the leaves and the second carry them.
  6. Finish with a sweep along the whole length toward the pile.

Tips

  • Clear leaves soon after they fall. After a few rainy days they mat down and stain light concrete.
  • Work with the wind, not against it.
  • For leaves packed into corners and cracks, a short, focused jet helps break them loose first.
  • Wear eye protection: wet grit flies too.

With a KLAAST

On the KLAAST Cordless Turbo Blower, fit the Storm 19.5-inch tube and use the top speed: 425 CFM and 120 mph move wet leaves on concrete. At 2.7 lb with the battery, you can hold it in one hand, standing up straight.